Hot and cold faucet repair
1. If the hot and cold water tap is controlled by a total inlet valve, close the main valve. When the hot and cold inlet
pipes are separated, close the two corresponding valves.
2, Use a flat-blade screwdriver to open the accessories " 01 hot and cold standard (handle fixed screw hole plug)";
3. Use a flat-blade screwdriver to reach into the handle to secure the screw hole plug (cold hot hole), countercloc-
kwise (left-handed) screwdriver about 3 turns; )"
4. Grasp the handle of the faucet with your left hand and push it upwards. At the same time, use the rear end
handle of the screwdriver (must be non-metallic material, otherwise it will damage the outer surface of the faucet),
so that the accessory “02 water outlet handle” is separated;
5. Counterclockwise (left-handed) fitting "03 end cap", the end cap is separated from the main body;
6. Use the front of the adjustable spanner to place the hexagonal position of the “04 core tightening hex sleeve” of
the accessory. Adjust the opening size of the adjustable spanner, rotate it counterclockwise, remove the ceramic
valve core and check it. If it is good, it will be clockwise (right-handed). Fix the strength; if it is damaged, replace
the new valve core.
7. Replace the accessories “03 end cover”, “02 water outlet handle” and “01 hot and cold standard” (note that red
represents hot water side and blue color represents cold water side).
If you need further information,please check our website:https://www.bzsanitary.com/